Peugeot 308 Key Fob Problems and How to Fix Them
If your Peugeot 308 key fob stopped working one day, it could be due to a dead battery in the coin or water damage or receiver module issues, or a malfunctioning electronic chip. These are all simple solutions that will get your car back up to speed in a matter of minutes!
Car keys can also fail due to the fact that the blade on the key gets worn. This is an easy fix when you visit your local Car Key Man Auto Locksmith and let them install an entirely new key blade for you.
Battery
The battery for the key fob in your Peugeot 308 can sometimes die or become insufficient to send a strong signal to the car. This can cause the key fob's function to cease and prevent you from locking or opening the doors or even starting your engine. To fix this, you'll need to replace the battery inside the key fob.
You'll need batteries for replacement from an auto parts store or a local hardware store. Make sure the battery is brand new and not on the shelf too long. A new battery has greater capacity and will send a stronger signal your car.
After replacing the battery If you have a new battery, try unlocking and locking the doors of your Peugeot using the key fob. If the doors do not unlock it is most likely to be with the receiver module of your car, which can be reprogrammed by your local Peugeot dealer.
The chip inside the key fob could also be damaged. This could happen when you drop your key fob on the ground or expose it to water. The rubber seals that shield the chip from moisture may get worn out over time, especially if your key fob is exposed to water for long periods of time, such as submerging it in the ocean at the beach. To prevent this from happening it is recommended to keep your key fob away of moisture and away from water.
Water Damage
Don't give up on your key fob when it gets wet, no matter if you slipped into an aquisition or stumbled into a puddle. While the key fob comes with rubber seals to protect it from water, prolonged exposure to water could result in damage to its electronic chip. Because water is a good conductor and conductor, any water that gets inside the key fob can cause a series of short circuits, which could eventually ruin the chip. After removing the battery clean the contacts with isopropyl alcohol, and dry it off completely before putting it back in.
Your Peugeot 308 may not start because of a dead battery. If you have a spare vehicle, jumper cables may be used to get the engine going again. If you suspect that the battery is at fault, it will need to be replaced.
A defective receiver in your car can also prevent it from receiving the signal from the keyfob. The key fob might be damaged, or there could be an issue with the antenna, wiring, or the key fob itself. If you're using a new key fob, it might need to be programmed for the vehicle. If you are unable solve the issue, contact an expert technician. A technician trained in the field will be able determine the issue quickly and then fix it right away.
Radio Interference
For example, a key fobs that are not recognized or having a narrow range of operation usually mean there is a problem with the system. The interference could be transmitted or radiated, which is caused by power and speaker cables getting too close to electrical parts. Generally, re-routing the cables or moving them further away from the components can solve the problem.
peugeot 107 key fob replacement that someone is listening in on the signals from your key fob to steal your car, however it's possible that your signal is being distorted by radio frequency interference. This is a simple problem to fix.
If your key fob is not being recognized by the system, try replacing the battery. Also, make sure that the battery is the right size and type. Incorrectly sized batteries can damage the fob.
Some aftermarket alarm systems and radar detectors operate on the same radio frequency as your key fob and they can cause them to interfere with your key signals. Avoid connecting these devices to your key fob.
Pairing Issues
The remote keyless entry system in a car has an antenna that receives radio signals from the key fob. It will not be possible to start your vehicle if this receiver isn't working, even if your key fob is in good working order and can be reprogrammed. The issue can be caused by a range of causes, including an inoperative coin battery or water damage. The receiver could also be malfunctioning because of a software bug or internal damage to the key.
One of the most frequent reasons that your Peugeot 308 key fob doesn't work is that the coin battery inside has gone out of service. It is easy to replace it with a new battery, but it's essential to select the correct battery for your key fob. It is best to use one that is the same size with the same voltage, specifications, and specifications as the original.
Your Peugeot 308 keyfob may not work if it has been associated with another vehicle. You may have accidentally given your key fob to someone else, or the key was used to unlock other vehicles. You can resolve this by reprogramming your key fob using an OBDII scanner. This tool will usually ask you for specific information regarding the vehicle, such as the VIN or engine type, and it's essential to fill in the correct information.